WMD Time Warp Dual Gated Voltage Slew & Envelope Follower
Finally, a dual slew, with the right interface, at the perfect size. Add some slide and smoothness to your patches on your own accord with Time Warp.
TIME WARP is a dual channel, gated slew module with some extra features that make a powerful and versatile addition to any Eurorack Modular Synthesizer System.
Its unique, Gated Slew function allows users to add slew to any voltage signal at designated times by sending it a gate signal from a sequencer or similar source. Switch it up with Invert Logic on the gate input, or use the switch as a real time performance tool for hands-on control over when the slew will take place.
With two modes of symmetry and a full wave rectifier on the input, Time Warp can function as 2 independent Slews, two A/R Envelopes with tied controls, or even as an envelope follower, taking audio and turning it into a useful envelope signal. CV control over the Rate of slew! Time warp puts all of that in a compact, 4hp package.
- INVERT LOGIC SWITCHES: Inverts
the logic of the GATE input. If the
switch is in the up position, the
slew will be enabled until the
gate input is above 3V. - RATE KNOBS / CV: Rate knobs
change function depending on
the position of the SYMMETRY
switch. In the left position, each
slew is linear symmetrical with
independent controls. In the
right position the slews switch
to non-symmetrical with shared
controls. - IN / OUT: Patch the signal you
would like to slew to the IN jack.
The slewed signal will be present
on the OUT jack. - ENVELOPE FOLLOWER:
The GATE jack acts as a switch
for a full wave rectifier enabling
each slew to act as an ENVELOPE
FOLLOWER. This mode is enabled
when nothing is plugged into the
GATE jack. - LED: Shows the state of the slew.
The LED will be lit if the slew is
enabled. - GATE: Use this input to toggle the
state of the slew depending on
how the INVERT LOGIC SWITCHES are set. If the corresponding
switch is in the up position the
slew effect will be enabled until
the GATE input goes high. If the
switch is in the down position a
high signal at the GATE input will
enable the slew effect
